Click the Exhibit button.

You work for ISP A, as shown in the exhibit, and must configure R1 to use load balancing across
both available links to ISP B’s network. Which command do you use to finish the configuration?

Click the Exhibit button.

The exhibit shows the output of a Junos show bgp neighbor command. Which two statements are
true? (Choose two.)

Click the Exhibit button.

Referring to the OSPF link metrics in the exhibit, which path will traffic from R6 take to reach R1?

Click the Exhibit button.

A customer is using the Layer 3 VPN multicast technology shown in the exhibit. Which statement
is true?

Click the Exhibit button.

In the exhibit, R1 is a route reflector and R2 through R5 are clients in a full mesh configuration. R2
should only receive one copy of all routes sent from R5.Which configuration is valid?

In an interdomain multicast deployment scenario, an RP1 is in AS1 and an RP2 is in AS2. MSDP
is configured between RP1 and RP2.In which routing table on RP1 are source-active messages
(SAs) received from RP2 by default?

Click the Exhibit button.

R3 and R4 want to establish an EBGP session between each other’s loopback addresses. They
have each configured static routes to the other’s loopback address and can ping from loopback to
loopback. Their EBGP session is configured with correct neighbor and local addresses. The

correct AS numbers have been specified at the [routing-options] hierarchy as well. Considering the
topology in the exhibit, which statement is true?

Click the Exhibit button.

R2 is announcing the 10.200/16 network to its IS-IS neighbors. No routing policies have been
applied to R3. Referring to the exhibit, will R5 have 10.200/16 as an IS-IS route?

You are facing BGP scaling issues and decide to add dedicated route reflectors to your network.
You notice that VPN routes are not being advertised by your route reflectors. Which three actions
can you take to solve this? (Choose three.)

What is the purpose of the no-cspf command?