— Exhibit — Click the Exhibit button. On AS1, which two attributes are used to influence
inbound traffic from the other ASs shown in the exhibit? (Choose two.)

— Exhibit — Click the Exhibit button. Referring to the exhibit, R2 is sending a route to R1 with
a community value. Which statement is correct?

Which set of BGP attributes is preferred by the Junos OS?

— Exhibit — Click the Exhibit button. Referring to the exhibit and based on the output below
from Sw-1 and Sw-2, which statement is true?

— Exhibit — Click the Exhibit button. R4 receives BGP prefixes for AS 50 from both R2 and
R3. You want to ensure that R4 chooses R3 as the preferred path to reach 50.50.50/24.
Referring to the information shown in the exhibit, where would you apply a policy containing
the parameter local-preference 110 to accomplish this task?

You want to provide reachability to your data center by advertising its subnet throughout
your upstream peer AS. However, you do not want this prefix advertised any further. Which
BGP community value would be used to meet this requirement?

— Exhibit — Click the Exhibit button. Referring to the exhibit, you want router A to have an
EBGP peering with router C. They are both connected through router B, which does not
have BGP running, and has static routes configured. What must be configured in the EBGP
peer groups on routers A and C to make this connection possible?

— Exhibit — Click the Exhibit button. Referring to the exhibit, your AS is connected to ISP-A
and ISP-B using BGP. R1 and R2 are advertising your AS’s 172.25/16 prefix upstream to
both ISPs, and both ISPs are providing a full BGP route table. You want to influence traffic
flow so that traffic towards your network enters through R1. Which action would meet the
requirement? Apply the following as an export policy towards ISP-B:

— Exhibit — Click the Exhibit button. R1 is connected to both R2 and R3 and you want to
load-balance outbound traffic. You have provided the configuration shown in the exhibit;
however, after checking the links you notice that the traffic is not load-balancing. Which
configuration must be added?

— Exhibit — Click the Exhibit button. Two routers are joined by redundant BGP connections.
You want to load-balance traffic across these links, and have configured the policy shown in
the exhibit on each device. Which configuration, applied on each device, correctly applies
the policy to accomplish this task?