Which three data rates are supported?
You have an AP with an 802.11b radio. You have installed it and want to know the data rates for it.
Which three data rates are supported? (Choose three.)
Which three types of interference sources would you expect to find from the analysis?
Your wireless clients are experiencing periodic interruptions on the network that might be due to
interference by another wireless device in the area. You decide to enable spectrum analysis on a
couple of radios in the affected area to determine the cause. Which three types of interference
sources would you expect to find from the analysis? (Choose three.)
Which panel in RingMaster would you use?
A network administrator wants to look at data throughput per radio. Which panel in RingMaster
would you use?
What is the hardware requirement for a RingMaster client?
What is the hardware requirement for a RingMaster client?
What are two advantages of using a locally switched data forwarding model?
What are two advantages of using a locally switched data forwarding model? (Choose two.)
which two situations does the wireless LAN system support the automatic load balancing of clients?
In which two situations does the wireless LAN system support the automatic load balancing of
clients? (Choose two.)
Which type of Service Profile in RingMaster should you configure?
You have wireless clients that are not part of the corporate network, but you want to allow them
access to the Internet without requiring a username and password. Which type of Service Profile in
RingMaster should you configure?
Which WLC feature would you use?
You want to copy 802.11 protocol messages from the RF channel to a specified observer running a
protocol analyzer. Which WLC feature would you use?
Which CLI command should you use to verify this?
Your manager asks you to verify that all access points in a cluster have a primary and secondary
controller assigned. Which CLI command should you use to verify this?
Which UDP port is used for RADIUS authentication by default?
Which UDP port is used for RADIUS authentication by default?