You are logged into a router and have navigated to the [edit routing-options] level of the hierarchy.
You have been asked to create a static route that will use 43 18 7 1 as its primary next-hop and 76
1310 2 as its secondary next-hop.
Which command correctly configures this setup?

Click the Exhibit button

Referring to the network illustrated in the exhibit, how does router A reach destinations in area
49.2222?

You have recently implemented a graceful Routing-Engine switchover (GRES) and want to further
reduce down time if a Routing Engine (RE) failure occurs.
Which two features can be configured on this device to reduce its downtime in this situation?
(Choose two)

Which BGP state denotes a fully operational session?

Click the Exhibit button

You work for the regional Internet service provider shown in the exhibit You have a partial BGP
table and are receiving a 10 100/16 route from your upstream ISP You have been asked to
configure a default route that can be sent to your downstream customer This route should forward
customer traffic toward your upstream Tier 11SP as long as the 10.100/16 route is present.
What would accomplish this goal?

Click the Exhibit button

In the exhibit, OSPF routers R1, R2, R3, and R4 come up, in order, at 1-minute intervals
Which router will be the designated router?.

You have been asked to configure an IPv6 address for a group of interfaces that could belong on
different routers. If a packet is sent to that address, it should be received by all routers in the
group.
Which address type would be suited for these requirements?

What is the function of the hop limit field in the IPv6 header?

You have been asked to define a default gateway for traffic leaving a router. This route should use
interface so-0/0/0 as its next-hop. Which type of route would be suited for this scenario?

Click the Exhibit button

In the exhibit, how many full OSPF adjacencies will R3 have?