Which two adjacencies are allowed to form when configuring IS-IS?
Which two adjacencies are allowed to form when configuring IS-IS? (Choose two.)
What is the maximum metric for that link?
A router is configured to use standard metrics. The router has a single link to a Level 2 IS-IS
neighbor.
What is the maximum metric for that link?
Which three configuration settings under the [edit protocols stp] hierarchy on an EX Series switch allow thi
You want STP to behave similar to RSTP.
Which three configuration settings under the [edit protocols stp] hierarchy on an EX Series switch
allow this? (Choose three.)
What describes the action of the qualified-next-hop parameter in a configuration?
What describes the action of the qualified-next-hop parameter in a configuration?
What are three terminating actions?
You are configuring a firewall filter and need to select a terminating action.
What are three terminating actions? (Choose three.)
how will the company router react to these updates?
A company’s Junos-based router has two EBGP peers and receives two BGP update messages
with the following information:
Peer A – AS path [ 65001 64513 12 ] ; MED 67 ; origin value 1
Peer B – AS path [ 65002 64513 12 ] ; MED 70 ; origin value 2
Assuming default values, how will the company router react to these updates?
You have been asked to configure a route to 192.168.0.0/16 that will only be active under the following criter
You have been asked to configure a route to 192.168.0.0/16 that will only be active under the
following criteriA.
There is an active route to 192.168.100.0/24.
The 192.168.100.0/24 route came from the protocol OSPF.
Which type of route accomplishes this task?
What are two BGP session types?
What are two BGP session types? (Choose two.)
Which configuration will satisfy the requirement?
You are asked to configure a port to support both tagged and untagged traffic. You want to make
the trunk port ge-0/0/0 and also accept untagged traffic for the data VLAN.
Which configuration will satisfy the requirement?
Which commands enable this?
You want to enable an Ethernet Link Aggregation Group (LAG) on an EX Series switch.
Which commands enable this?