Which two commands will help?
Your ISP reports that you are being sent a route prefix but you cannot see it in your routing table.
Which two commands will help? (Choose two.)
What must be done to allow the commit to complete?
— Exhibit —
[edit]
user@router# commit
[edit protocols]
‘bgp’
Error in neighbor 172.27.1.4 of group ebgp:
must define local autonomous system when enabling BGP
error: configuration check-out failed
— Exhibit —
You are configuring BGP on a new router. While attempting to commit the configuration, you
receive the error shown in the exhibit.
What must be done to allow the commit to complete?
which command is used to verify this information on R1?
Which command would you use to accomplish this task?
You must verify whether the prefix 172.28.102.0/24 has been advertised by BGP peer 172.18.1.1
and accepted into the routing table.
Which command would you use to accomplish this task?
Which command would you use?
Prefix 172.28.102.0/24 has been advertised by BGP peer 172.18.1.1. You must verify that it has
been received by your Junos device before a policy has been applied.
Which command would you use?
Which two statements describe the differences between the proposed solutions?
You are asked to identify a tunneling solution between two remote sites and are considering GRE
and IP-IP tunnels to meet the requirement.
Which two statements describe the differences between the proposed solutions? (Choose two.)
Which two statements are correct?
You are asked to deploy a GRE tunnel between two remote sites.
Which two statements are correct? (Choose two.)
Which two reasons would cause this problem?
You have deployed a GRE tunnel between Site A and Site B. The tunnel interfaces are up on both
tunnel endpoints but traffic is not being passed between the remote sites.
Which two reasons would cause this problem? (Choose two.)
Which action would resolve this problem?
You have configured a GRE tunnel between two remote sites. This tunnel will be used to pass
traffic using RFC 1918 addressing over the Internet. You have verified that the tunnel interface is
up on both endpoints and see the output shown below:
user@router> show interfaces gr-0/0/0.0 terse
Interface Admin Link Proto Local Remote
gr-0/0/0.0 up up
Traffic between the remote sites is not being passed over this tunnel.
Which action would resolve this problem?
Which two statements are true about RTG?
Which two statements are true about RTG? (Choose two.)