What are two benefits of integrating Junos Pulse Access Control Service with Security Threat
Response Manager (STRM)? (Choose two.)

You have a firewall enforcer receiving resource access policies from a Junos Pulse Access
Control Service. You are using Network and Security Manager (NSM) for configuration
management on that firewall. The firewall can also be configured using its built-in command-line
interface (CLI) or Web-based user interface (WebUI).
To avoid conflicting configurations, which two interfaces must you use to configure the firewall
enforcer? (Choose two.)

End users want to map a network drive on their PCs when they are connected to the Junos Pulse
Access Control Service. The mapped drive must be removed when users disconnect their session.
Which feature addresses this requirement?

Your corporate security policy requires that a user performing attacks must have limited network
access and activities until an administrator can investigate.
In the admin GUI, which sensor event policy action must you configure in “Configuration” >
“Sensors” > “Sensor Event Policies” > [rule name] to accomplish this?

You are the network administrator for your company. A user is complaining that they are not able
to access the network with the Junos Pulse client. You run a packet capture on the network
interface to monitor the 802.1X authentication process. You notice that after the EAPrequest/identity packet is received, and the supplicant responds with an EAP-response/identity
packet, no further communication occurs for several seconds.

What are three causes for this behavior? (Choose three.)

When using RADIUS as an external authentication method for 802.1X authentication for the Junos
Pulse Access Control Service, what must you do to ensure that the RADIUS authentication works
properly?

You are validating the configuration of your SRX Series device and see the output shown below.

What does this indicate?

In the admin GUI, you navigate to “System” > “Status” > “Active Users”. You see several buttons,
including “Delete Session”, “Delete All Sessions”. “Refresh Roles”, and “Disable All Users”.
Which two statements are true? (Choose two.)

Which three features are supported with the Junos Pulse client? (Choose three.)

You are deploying a Junos Pulse Access Control Service cluster in active/passive mode. How do
you configure the IP address on the SRX Series devices?