Which two protocols use UDP as a transport protocol by default?
Which two protocols use UDP as a transport protocol by default? (Choose two.)
Which network mask is the equivalent of 255.255.248.0?
Which network mask is the equivalent of 255.255.248.0?
Which network mask meets this requirement?
You have been assigned the /24 network and need to segment it into at least 60 subnets.
Which network mask meets this requirement?
Which network mask do you use?
You must segment your internal /24 network into a minimum of 12 subnets, each containing a
minimum of 12 hosts.
Which network mask do you use?
What are the usable hosts on the .128.0/19 network?
What are the usable hosts on the .128.0/19 network?
How many usable hosts are available?
You have been allocated a /22 network.
How many usable hosts are available?
How many usable host addresses will there be per subnet?
You have been asked to use a 23-bit network mask to segment the network block 209.18.12.0.
How many usable host addresses will there be per subnet?
Which step should be taken to solve the problem?
user@router# run show interfaces terse
Interface Admin Link Proto Local
fe-0/0/0 up up
fe-0/0/0.0 up upinet 10.0.39.2/24
iso
mpls
fe-0/0/1 up up
fe-0/0/1.0 up upinet 10.0.18.2/24
fe-0/0/1.5 down up inet 10.0.19.2/24
An administrator is unable to ping any address on the 10.0.19.0/24 subnet. To identify the
problem, the administrator uses the command shown in the exhibit.
Which step should be taken to solve the problem?
which command would you use to add an additional address to the ge- 0/0/9.0 interface?
interfaces {
ge-0/0/8 {
unit 0 {
family inet {
address 192.168.1.1/24;
} } }
ge-0/0/9 {
unit 0 {
family inet {
address 192.168.10.1/24;
} } }
}
Referring to the exhibit, which command would you use to add an additional address to the ge-
0/0/9.0 interface?
what is the purpose of the targets section of the configuration?
[editsnmp]
user@router# show
communityCommunityA {
authorization read-only;
clients {
192.168.1.0/28;
}
}
trap-groupgroupA {
categories {
link;
}
targets {
192.168.100.1;
192.168.200.1;
}
}
Referring to the exhibit, what is the purpose of the targets section of the configuration?