Which two values are used to generate a bridge ID when using STP? (Choose two.)

What is considered a requirement for passing traffic through GRE tunnels?

Click the Exhibit button.

You are establishing a BGP session between R1 and R2. R2 shows 172.24.1.1 as its peer address for R1
instead of 192.168.100.1.
Referring to the exhibit, what must be changed in the configuration?

An EX Series switch receives a frame with an unknown destination MAC address.
What is the expected behavior?

What are three types of bridge protocol data units? (Choose three.)

Click the Exhibit button.What would cause the status of interface ge-0/0/8 as shown in the exhibit?

Click the Exhibit button.

You have an existing Virtual Chassis consisting of five member devices. Member 3 fails and must be replaced.
You remove the EX Series switch with a Member ID of 3 and install a replacement switch in its place using
identical cabling as shown in the exhibit. The replacement’s member ID is 6, so the configuration for member
ID 3 is not applied to it.
Referring to the exhibit, what should have been done before installing the replacement switch?

Which two statements describe the BGP Local Preference attribute? (Choose two.)

Click the Exhibit button.

Referring to the exhibit, which statement explains why the route to 192.168.178.0/24 advertised from
192.168.35.90 is hidden?

Click the Exhibit button.

You manage the Layer 2 network shown in the exhibit. You experience a failure on the ge-0/0/0 link between
Switch-1 and Switch-2.
Which statement is correct about the expected behavior?