What would explain this behavior?
You configured an aggregate route of 192.168.8.0/21 and committed the updated configuration. Using an operational show command, you notice that the newly configured route is not present in the output. What would explain this behavior?
what will be the source address of the packet arriving at the host D?
See the Exhibit:
Exhibit:
In the exhibit, If Host A initiates a web browsing session with host D and the E0/1 interface of the SSG 20 is in Nat mode, what will be the source address of the packet arriving at the host D?
what is the correct command to configure a default route on the SSG 20?
Click the Exhibit button.
In the exhibit, what is the correct command to configure a default route on the SSG 20?
which routing command would allow host A to communicate with host D?
Click the Exhibit button.
In the exhibit, which routing command would allow host A to communicate with host D? (Note:
Assume a route from the SSG 20 to host A’s subnet already exists.)
Which type of route would you configure on your device to accomplish this objective?
On an edge router, you want to create a default route with a next hop to an external connection. The route should be available only when you are receiving routes from the external provider. Which type of route would you configure on your device to accomplish this objective?
Which configuration command would you use to add an IPv6 static route to your Junos device?
Which configuration command would you use to add an IPv6 static route to your Junos device?
which address will be used as the outbound source address of packets destined for the Internet?
Click the Exhibit button.
In the exhibit, if you configure NAT-src on interface e0/4, and specify a DIP with address 143.45.56.31, which address will be used as the outbound source address of packets destined for the Internet?
Which ScreenOS CLI command would allow all policies in the exhibit to match traffic?
Click the Exhibit button.
Which ScreenOS CLI command would allow all policies in the exhibit to match traffic?
which address will be used as the outbound source address of packets destined for the Internet?
Click the Exhibit button.
In the exhibit, if you configure NAT-src on interface e0/4, and do not specify a DIP, which address will be used as the outbound source address of packets destined for the Internet?
Which command will allow you to configure the Ethernet interface to have the IP address shown in the exhibit?
Click the Exhibit button.
Which command will allow you to configure the Ethernet interface to have the IP address shown in the exhibit?