Which of the following mechanisms are used for flow control?
Which of the following mechanisms are used for flow control? (Choose three)
which layer is responsible for end to end error checkin…
According to OSI reference model, which layer is responsible for end to end error checking and flow control?
What can the administrator determine from this?
While inspecting packets in the network, a network administrator discovers a frame with the destination MAC
address of 01-00-5E-A0-B1-C3.
What can the administrator determine from this?
Which of the following represents this mode?
An Ethernet port can work one of three duplex modes, whereas an Optical Ethernet port only supports one single mode.
Which of the following represents this mode?
What will occur as a result?
The network administrator wishes to transmit data between two end stations. The network interface cards of
both devices operates at 100Mbps however one supports half duplex while the other uses full duplex mode.What will occur as a result?
which of the following commands can be used to set port…
On Huawei switch, which of the following commands can be used to set port duplex mode as “auto
negotiation”? (Choose two)
what steps can the administrator take?
The network administrator wants to improve the performance of network transmission, what steps can the
administrator take? (Choose two)
Which of the following statements are correct regarding…
Refer to the configuration output. Which of the following statements are correct regarding the configuration of
the ACL on RTA? (Choose two).
Which of the following statements is correct regarding …
What actions can be taken by the administrator to preve…
Following a failure of services in the network, an administrator discovered that the configuration in one of the
enterprise routers had been changed.
What actions can be taken by the administrator to prevent further changes? (Choose three)