Which of the following commands is used to display the …
Which of the following commands is used to display the OSPF neighbor relationship establishment?
Which of the following VRP commands can be used to ente…
Which of the following VRP commands can be used to enter area 0 view? (Choose two)
Which of the following statements regarding the DR in a…
Which of the following statements regarding the DR in an OSPF network are correct? (Choose two)
Which of the following steps are necessary to configure…
Which of the following steps are necessary to configure OSPF on a Huawei router? (Choose three)
Which of the following statements regarding link-state …
Which of the following statements regarding link-state database and routing-table of a “single” OSPF area are
correct? (Choose two)
Which of the following statements regarding route shown…
10.0.1.0/24 O_ASE 150 2 D 10.0.23.3 Serial2/0/0
Refer to the display output. Which of the following statements regarding route shown are true? (Choose two)
Which of the following statements regarding single area…
Which of the following statements regarding single area OSPF are correct? (Choose three)
Which of the following points should the administrator …
An administrator of a company supporting a large enterprise network wishes to implement OSPF on the
network as opposed to RIP. Which of the following points should the administrator use to support his reasoning
for this change? (Choose three)
Which value will be used as the router ID?
The administrator wishes to configure OSPF on a router in the network however the router has no loopback
interface.
Which value will be used as the router ID?
Which of the following OSPF versions is specific to IPv6?
Which of the following OSPF versions is specific to IPv6?