Examine the following partial outputs from two routing debug commands; then answer the question below.
# get router info routing-table database
s 0.0.0.0/0 [20/0] via 10.200.2.254, port2, [10/0]
s *> 0.0.0.0/0 [10/0] via 10.200.1.254, port1
# get router info routing-table all
s* 0.0.0.0/0 [10/0] via 10.200.1.254, port1
Why the default route using port2 is not displayed in the output of the second command?
A.
It has a lower priority than the default route using port1.
B.
It has a higher priority than the default route using port1.
C.
It has a higher distance than the default route using port1.
D.
It is disabled in the FortiGate configuration.