Refer to the exhibit.

An LTM Specialist is upgrading the LTM devices.
Which device should be upgraded first?

Refer to the exhibit.

Which profile could be removed or changed on this virtual server to reduce CPU load on the LTM device
without increasing server side bandwidth usage?

Refer to the exhibit.

Which pool can be removed without affecting client traffic?

Refer to the exhibit.

Which two items can be consolidated to simplify the LTM configuration? (Choose two.)

Refer to the exhibit.

An LTM Specialist is reviewing the ‘test’ partition.
Which objects, in order, can be removed from the partition?

Refer to the exhibit.

An LTM Specialist is reviewing the virtual server configuration on an LTM device.
Which two actions should the LTM Specialist perform to minimize the virtual server configuration? (Choose
two.)

An LTM device pair is configured for failover and connection mirroring. The LTM devices are configured
with virtual servers for HTTP, HTTPS with SSL offload, and SSH. An event occurs that causes a failover.
HTTP and SSH sessions active at the time of failover remain active, but HTTPS sessions are dropped.
What is the root cause of this problem?

A failover event is recorded in the following log messages:
Jan 01 00:56:56 BIG-IP notice mcpd[5318]: 01070727:5: Pool /Common/my-pool member /
Common/10.0.0.10:80 monitor status down.
Jan 01 00:56:56 BIG-IP notice sod[5855]: 010c0045:5: Leaving active, group score 10 peer group score 20.
Jan 01 00:56:56 BIG-IP notice sod[5855]: 010c0052:5: Standby for traffic group /Common/traffic-group-1.
Jan 01 00:56:56 BIG-IP notice sod[5855]: 010c0018:5: Standby
Jan 01 00:57:06 BIG-IP notice logger: /usr/bin/tmipsecd –tmmcount 4 ==> /usr/bin/bigstart stop racoon
What is the cause of the failover?

A device group is made up of four members: LTM-A, LTM-B, LTM-C, and LTM-D. An LTM Specialist
makes a configuration change on LTM-B. Later, a different LTM Specialist notices a “changes pending”
message on all devices. When logged into LTM-D, the LTM Specialist attempts to config-sync to the device
group. The sync operation fails.
Why is the LTM Specialist on LTM-D unable to synchronize the configuration to the group?

An HA pair of LTM devices configured in Active-Standby mode stops responding to traffic and causes an
outage. The Active device becomes Standby, but the partner device stays in Standby mode instead of
taking over as Active. A reboot and restart of the services brings the LTM device to Active mode for a short
time, but then it goes into Standby mode again.
Which two configuration components caused this condition? (Choose two.)