One Comment on “Which EMC Avamar utility is used to configure a multinode server within a NAT environment?”

1. Jake says:

   November 22, 2014 at 12:05 am

   A is correct.

   The dpnnetutil utility will configure networking on an Avamar server beyond basic IP
   settings. This utility creates the probe.xml file on the utility which lists the storage node IP
   addresses. Without this file, the utility node is not aware of its storage nodes.
   Running dpnnetutil is not always necessary. The probe.xml file can also be generated later,
   during the Avamar software installation. However, only basic networking configurations can
   be configured with the Avamar installation GUI. If using VLAN or NAT, running dpnnetutil is
   required

   
   
   
   0

   
   
   
   0