You are deploying a new Windows 2000 host into your SAN and have performed the following steps:
-Physically connected the host to the SAN
-Installed the Master and Host agents on the host
-Used SAN Manager to zone the Host’s HBA to the Symmetrix port FA5b0
-Used SAN Manager to add the new zone to a new copy of the active zoneset and then activate that zoneset
-Used SDR to map device 02A to port FA5b0
-Used the Masking Wizard to mask device 02A to the host’s HBA -Rebooted the Windows Host
After completing this process, the host still does not see device 02A
What is most likely the problem?
A.
You did not discover the host HBA prior to zoning the fabric nodes
B.
You did not specify the RAID protection of the device to be allocated to the host
C.
You activated the wrong zoneset
D.
You forgot to refresh the VCMDB after changing the masking configuration