What is the first thing that happens when the Data Mover fails?
An NS-series system is equipped with only one Data Mover.
What is the first thing that happens when the Data Mover fails?
What is Intelligent Platform Management Interface (IPMI)?
What is Intelligent Platform Management Interface (IPMI)?
What could be the potential problem?
An NS Control Station is unable to access the back-end when the administrator runs the nas_disk
command. What could be the potential problem?
Where is the FLARE code loaded in a CLARiiON array?
Where is the FLARE code loaded in a CLARiiON array?
Which Celerra NS component is supplied with power by the SPS?
Which Celerra NS component is supplied with power by the SPS?
what speed should be used for your HyperTerminal session?
When examining the boot sequence of the Data Mover over a serial connection, what speed
should be used for your HyperTerminal session?
without changing the associated zoning?
Which zoning method allows the storage administrator to replace an HBA. without changing the
associated zoning?
Which CLARiiON RAID, configurations are supported with Celerra NS?
Which CLARiiON RAID, configurations are supported with Celerra NS?
for the third disk-array enclosure?
Each disk-array enclosure has a Loop (or Bus) ID. and an Enclosure ID. which is set by the
Enclosure Address Switch. What are the recommended EMC. Enclosure ID. and Loop ID. for the
third disk-array enclosure?
Which components are connected to the internal Ethernet switch?
A customer has purchased a gateway NS-series system. Which components are connected to the
internal Ethernet switch?