When creating a new Symmetrix logical volume with SMCLI, which unit can be used to specify the
size?

Refer to the Exhibit.

The SAN zones (Zones 3 and 4) shown in the exhibit have been created during an Open
Replicator implementation. The control devices in the Symmetix array are mapped to all four front-end ports. Which Open Replicator operations can be performed?

What is required when the symdev list command shows the TDEVs (?!) are in a Not Ready state?

A customer using Symmetrix Virtual Provisioning reports their thin pool has reached 50%

utilization. At which utilization level would you recommend adding more capacity to the thin pool?

Open Replicator will be used to move data from a Symmetrix V-max array to a CLARiiON array.
The CLARiiON array has NOT been discovered by the host on which Open Replicator commands
are issued. Which information has to be specified in the Open Replicator device File?

While implementing a new Symmetrix solution, the customer requests that five new hosts be
added to the project. This is outside the scope of the project.
Which step needs to be taken?

Open Replicator Cold Push will be used to move data between a Symmetrix V-Max array and a
third-party array. Which step is required before issuing the Open Replicator create command?

A customer wants to implement incremental Open Replicator. What is a valid operation?

TimeFinder/Snap virtual devices will be used as the control devices in an Open Replicator
implementation. Which Open Replicator copy operation is supported?

One of the requirements during an Open Replicator implementation is to provide all available
resources to Open Replicator. How should the Pace and Ceiling values be configured?