An EMC NetWorker backup client contains 650 GB of data in 750,000 files and is presently
being backed up by an EMC NetWorker server to a tape library with six tape drives
connected to a Fibre Channel switch. Due to the total size of its data and the number of
files, the backup cannot complete during the required backup window. According to EMC
best practice, how can this issue be resolved?

What combination of simultaneous backups and recoveries is supported when using an
advanced file type device in EMC NetWorker?

A customer is adding new tape devices to an EMC NetWorker server. The command is
issued to scan for devices but does not find the new devices. What is the most likely cause?

In an EMC NetWorker environment, a clone volume (physical tape) required for a recovery
is not currently mounted. Which attribute is consulted first to determine the storage node
used for the recovery?

During the configuration of a tape library attached to a remote EMC NetWorker storage
node, an “Access denied” error message is reported. What is the root cause of the issue?

You have a requirement to set up a NAS appliance into the EMC NetWorker environment.
You have the remote username and passwords as well as the Fully Qualified Name (FQN)
for the device and you wish to ensure that the NetWorker server can see the NDMP devices
before the setup. Which command should be used to do this?

Refer to the exhibit. To which EMC NetWorker pool is the client save set backed up?

A client save set is backed up to an EMC NetWorker backup pool and later cloned to a
volume in a clone pool. On the volume, what property determines when the volume in the
clone pool is a candidate for recycling?

A customer is adding a new jukebox to an EMC NetWorker environment. The jukebox is
connected and powered on. The customer powers on the NetWorker server and verifies the
new library is visible to the OS. The customer brings up the Device Administration window
and verifies the existing jukebox is functioning properly. However when the customer
attempts to configure the new library using the Device Administration window function
“Configure All Libraries”, it fails to configure and instructs the customer that they must use
jbconfig to manually configure this library. What is the most likely reason that the customer
is forced to use jbconfig rather than the Device Administration window?

Which EMC NetWorker command can be used to determine the number of records in the
Client File Index for each client?