what happens automatically when the volume becomes full?
When using a NetWorker advanced file type device, what happens automatically when the volume becomes full?
What is a disadvantage of a backup-to-disk solution versus a backup-to-tape solution?
What is a disadvantage of a backup-to-disk solution versus a backup-to-tape solution?
What would you see if Server Parallelism were increased?
You are trying to improve backup performance in Certkiller .com’s environment. Your test results indicate that the sum of the backup rates (MB/sec) from all client disks being backed up is greater than the maximum rate of the backup device. What would you see if Server Parallelism were increased?
What is the problem with this configuration?
Certkiller .com wants to license replication on two DL740 systems. They are attempting to copy a virtual tape from one DL740 over an IP link to a physically attached tape library on the remote DL740. What is the problem with this configuration?
What is the problem with this configuration?
Certkiller .com wants to connect a DL720 with Active Engine Failover to their switched fabric environment. They will be using the following NetWorker Storage Nodes:
Three Windows 2003 Advanced Servers
Two Solaris 9 Servers
What is the problem with this configuration?
What is the best way to implement this policy?
The NetWorker Clients Bongo and Flute need to be full backed up at the same time every Sunday. What is the best way to implement this policy?
Which array would you recommend to Certkiller .com looking for NDMP source functionality?
Which array would you recommend to Certkiller .com looking for NDMP source functionality?
What are two factors that determine the required NetWorker edition?
What are two factors that determine the required NetWorker edition?
Which type of replication mode do you use?
Certkiller .com wants to replicate virtual tapes from a DL310 to a DL720. Replication must start once the backup software issues a command to remove the virtual tape from the virtual library. Which type of replication mode do you use?
How can you increase the number of front-end ports?
You are designing a solution for Certkiller .com using a DL740 as the backup target. During the process, you discovered that the solution will require more front-end ports than this model initially provides. How can you increase the number of front-end ports?