Refer to the exhibit

What is the correct state for the Standard issuing a symreplicate start command?

Refer to the exhibit

A Symmetrix is configured with two RDF groups, RDFG 1 and RDFG 2, as shown. The SRDF R1 devices used by Application 1(App 1) and Application 2 (App 2) are in RDFG 1. The SRDF devices used by Application 3 (App 3) are in RDFG 23

What should be created to enable SRDF/A for App 1 and App 2?

What is a supported deployment option for Open Replicator?

What replication operations are supported by the symmetrix management console?

What should be done before a thin device can be unbound from a thin pool?

The customer is considering a long-distance replication solution. Due to bandwidth limitations and distance SRDF/A has been selected. The customer has called the EMC TA to review his RPO. Selected minimum cycle limitof 30 seconds, what is the worst-case RPO under normal operating conditions?

What is a requirement when implementing TimeFinder/Clonein a virtual provisioningenvironment?

Use enginuity Consistency Assist, where is the I/O paused during a TimeFinder/Clone consistent activation???

A symclone create command was issued and the clone has not yet been activated. At this point what is the state of clone target device?

How are the tracks on the Control device marked during an Open Replicator Hot push creation?