How can you verify all the information?
You are deploying a RecoverPoint cluster into an existing VPLEX environment. You want to
validate the following conditions: -VPLEX splitters are installed -All VPLEX splitters are the
same version – VPLEX splitter status In addition, you want to verify that the VPLEX
management server can reach all of the attached RecoverPoint clusters. How can you verify
all the information?
What might cause this issue?
A company already using RecoverPoint/SE has just finished installing and configuring
VPLEX. They are unable to use the VPLEX splitter. What might cause this issue?
what is the only storage authentication method that is supported?
When adding a new vRPA, what is the only storage authentication method that is
supported?
What should the company consider before making the proposed change?
A company has a RecoverPoint environment with 20 Consistency Groups doing remote
replication. A new building was just acquired for disaster recovery and they want to move to
this new location. The IP addresses and cluster name are going to be changed. What
should the company consider before making the proposed change?
what value can be changed from the Environment Settings screen in Deployment Manager?
When modifying a cluster’s settings, what value can be changed from the Environment
Settings screen in Deployment Manager?
What should the customer do to correct the issue?
A customer has a four-node RecoverPoint cluster using a VNX array. All LUNs are
replicating and failover has been tested. The customer would like to integrate RecoverPoint
and Unisphere. However, they are unable to manage the cluster through Unisphere. What
should the customer do to correct the issue?
What can be done?
A customer has a four-node RecoverPoint cluster replicating over a 10 Mbps WAN link.
They have a requirement to upgrade the WAN link to 1 Gbps. This will require a change of
the default gateway on the RPAs. They need to accomplish this with as little impact as
possible. What can be done?
What is most likely the cause for this connection problem?
You are adding a new vRPA to a cluster using the Add New RPAs wizard in Deployment
Manager. SAN diagnostics fail and you cannot add the RPA,. Pings to the vRPA and VNX
iSCSI ports are returned successfully. What is most likely the cause for this connection
problem?
Which IP address allocation policy should be selected?
During deployment of a vRPA OVF template a temporary IP address must be set to be used
by Deployment Manager in later steps. Which IP address allocation policy should be
selected?
Which host command, run as the boxmgmt user, is available from the ‘Run Internal Command’ menu?
Which host command, run as the boxmgmt user, is available from the ‘Run Internal
Command’ menu?