On a CX700 SPE how many back-end Fibre Channel ports are there?
On a CX700 SPE how many back-end Fibre Channel ports are there?
Name the two EMC software packages which should be used on the Sun host? (Choose two)
Directly connected to a CX600 is a Sun host with two HBA’s. Name the two EMC software packages which should be used on the Sun host? (Choose two)
Explain how this could be accomplished.
Certkiller .com has installed a new LP9002 card in their Windows host. They want to hard code the HBA to run only in 2 GB mode. Explain how this could be accomplished.
(Choose three.)
Certkiller .com is planning to deploy database applications over raw devices. Name three appropriate storage solutions. (Choose three.)
(Choose two.)
Explain the benefits of concatenated metealUNs over striped metaLUNs. (Choose two.)
Name the correct cable configuration to connect the CX400?
Into an existing SAN with two DS-16Bs switches implemented as separate fabrics, Certkiller .com is installing a CX400. They will also be installing multiple windows servers with dual HBAs and PowerPath.
Name the correct cable configuration to connect the CX400?
State the maximum number of HA hosts that can be attached to the storage array.
Certkiller .com has recently purchased a CLARiiON CX400 storage array which is to be used by multiple hosts as part of HA SAN environment. State the maximum number of HA hosts that can be attached to the storage array.
What should you do, using Navisphere Manager.
A certain storage administrator suspects that a particular host is not configured to access both paths installed on a CLARiiON CX400. What should you do, using Navisphere Manager.
Name the possible cause of this problem on SPB.
You set up the IP addresses on the CX600 SPs. Afterwards, you find that only SPA is managed on the Navisphere Manager and not SPB, then you verify that the IP address information was correctly entered into the SP. Name the possible cause of this problem on SPB.
Explain which statement is correct about the new fault.
After an SP is re-inserted into a CX600 to clear a fault and is powered up, it shows as active in Navisphere manager. Approximately thirty seconds later, Navisphere Manager shows that the SPS is now charging for the same SP. Explain which statement is correct about the new fault.