A customer needs a RAID configuration that can maintain 500 host IOPs. The workload has
a profile of 90% reads and 10% writes. The customer is also trying to reduce the amount of
drives to buy. What RAID configuration would meet the customer’s requirements?

A Customer needs a RAID configuration that can maintain 650 host IOPs. The workload has
a profile of 90% reads and 10% writes. The customer is also trying to reduce the amount of
drives to buy. What RAID configuration would meet the customer’s requirements?

A Customer is creating a new configuration which requires a ratio of 90% reads and 10%
writes. The configuration will also need to handle very large I/O sizes. The customer is also
concerned about cost and availability of the data. What RAID configuration would meet the
customer’s requirements?

A Customer is creating a new configuration which requires a ratio of 10% reads and 90%
writes. The configuration will also need to handle very small I/O sizes. The customer is also
concerned about the performance of the new drives. What RAID and drive configuration
should be recommended?

A customer is creating a new configuration that has 100% sequential reads with very high
thread counts. The configuration will be for a test bed which will require no high availability or
fault tolerance on failures. What RAID and drive configuration should be recommended?

Click the calculator icon in the upper left-hand corner. An application generates 1000 IOPS
with a read/write ratio of 3:1. What is the difference in disk IOPS between RAID 1/0 and
RAID 5 for this workload?

Which naviseccli performance counter is used to view stripe boundary crossing statistics?

Refer to the Exhibit.

A VNX Administrator is monitoring the workload and is considering adding a few flash drives.
Based on the workload shown in the illustration, what would be the outcome of adding these
drives?

In reviewing a nar analysis, what does workload skew measure?

If the workload graph shows that most of the Storage Processor load is used to support a
small amount of data, what could cause this utilization?