Refer to the exhibit.

You have created a Distributed Device in a VPLEX Metro. You want to confirm you have chosen the correct
volumes before performing a mobility job across clusters. You will be moving the device to cluster 1.
Which object will be the source for this operation?

Refer to the exhibit.

After 6 months of operation, you are monitoring the health of the VPLEX system from the Unisphere Manager
for VPLEX.
What is the most likely reason for a state change of the VPLEX Witness?

Refer to the exhibit.

You are planning to perform data mobility between VPLEX Clusters using the GUI. What mobility job options do
you have?

Refer to the exhibit.

After the “attach-mirror” command is successfully executed on device “device_VNX0506_CSE__6_1”, the
command “rebuild-status” shows an ongoing rebuild process on the same device.
What is a possible cause?

Refer to the exhibit.

What is the result of the command?

Refer to the exhibit.

A customer is moving some VMAX devices under a VPLEX Local and is using PowerPath as multipath
software. What is the preferred PowerPath load balancing policy assigned to VPLEX volumes?

Refer to the exhibit.

Which command must be used to generate this output?

Refer to the exhibit.

NDU pre-check failed because minimal topology is in use. Which parameter can be added to the ndu start
command that will allow the NDU to proceed without error in this situation?

Refer to the exhibit.

You are preparing to upgrade a VPLEX Metro system. You ran the version command to begin the verification
process and received the output shown.
What is the most likely reason for the warning?

Refer to the exhibit.

What is the purpose of VPLEX Witness in a Metro environment?