What aspect of VPLEX assigns and remembers chunk ownership?

Exhibit:

Which VPLEX object contains virtual-to-physical mapping information and must be stored on multiple arrays?

Refer to the exhibit.

You are performing a health-check on a VPLEX VS2 Metro system. After running several commands, you
notice port errors on the VPLEX directors.
What does the information listed under Checking ports status indicate?

Refer to the exhibit.

You are implementing a VPLEX Metro configuration, and some BE ports are not logged into the fabric.
Which VPLEX command should be performed?

Refer to the exhibit.

During a short power disruption to cluster 2, director-2-1-A had failed. Power was restored after 5 minutes. In
examining the output of the vault status command, you note that cluster-2’s status reads “Cluster is not
vaulting/unvaulting”.
Why did this message appear?

Refer to the exhibit.

the message type shown at point “1”.
What type of response will be sent back to the SNMP management server from the SNMP Agent?

Refer to the exhibit.

You are preparing to perform an upgrade on an unconfigured VPLEX Metro. When you run the ndu pre-check
command, it indicates that it has failed and there are no first upgraders. In your troubleshooting, you run the
version -a command.
Based on the output, what is the reason for the failure?

Refer to the exhibit.

A customer needs to provision storage to a host on Cluster 1, but there is no additional local array capacity to
allocate. How could the customer facilitate assigning storage to the Cluster 1 host from an array locally
connected to Cluster 2?

Refer to the exhibit.

The customer deleted ext_2 on a 20 GB LUN in order to make an extent of 10 GB. Why is the customer unable
to create a 10 GB extent?

Refer to the exhibit.

You have created a Distributed Device in a VPLEX Metro. You want to confirm the volumes before performing a
mobility job within the cluster. You will be moving the device to cluster 1.
Which object will be the source for this operation?