What happens if only cge0 fails?
Refer to the exhibit:
Both virtual devices (lacp0 and lacp1) are used to create another virtual device “fsn0”. lacp0 is the
primary.
What happens if only cge0 fails?
What can be done to accommodate these interfaces on three separate subnets?
Three different IP interfaces have been defined for a single port on a Data Mover. What can be
done to accommodate these interfaces on three separate subnets?
Which objects should NOT be archived?
Which objects should NOT be archived?
What is one possible cause for this?
One of the Celerras in the data center dropped all client access suddenly. Upon further
investigation, you discover that the primary blade is in a panicked state but did not fail over to the
standby blade.
What is one possible cause for this?
Which profile will be used if an application only specifies an IP address of the Centera cluster?
Which profile will be used if an application only specifies an IP address of the Centera cluster?
what two addresses of the new primary Data Mover?
If a primary Data Mover becomes unavailable, the standby uses what two addresses of the new
primary Data Mover?
What are the possible disk configurations/Celerra storage pools that can be made using these disks?
You are implementing a Celerra gateway system into an existing CLARiiON back end with 11
available EFDs.
What are the possible disk configurations/Celerra storage pools that can be made using these
disks?
Which operating system runs on the Centera storage and access nodes?
Which operating system runs on the Centera storage and access nodes?
Which Data Mover component is designed to improve response time for user mapping requests?
Which Data Mover component is designed to improve response time for user mapping requests?
What will be resulting root file system name?
A storage administrator created a new Virtual Data Mover with the name “vdm01” using the
following command:
$ nas_server –name vdm01 –type vdm –create server_2 –setstate loaded
What will be resulting root file system name?