Why would you boot to the utility partition?

A customer engineer (CE) has successfully powered up a factory-installed VNX Unified storage
system. The CE now needs to configure the Control Station for network access.
What is required of the PC running the VIA to successfully discover the Control Station?

Which system check is performed during the installation of a VNX File Unified system?

Which part is a Customer Replaceable Unit?

What does the server_route command configure?

An operator must shut down the standby Control Station CS1 on a VNX configured with dual
Control Stations. What action, if any, does the operator need to take to allow management and
monitoring of the VNX to continue when CS1 is offline?

Which VNX models use a disk processor enclosure (DPE)?

You are onsite for a DAE and drive upgrade for a VNX 7600 array. After inspecting SP Collects
from the array you notice that the VNX has the following active configuration:
1 x 2.5″ DPE
36 x 2.5″ DAE’s
919 total drives
914 bound data and hotspare drives
6 empty slots
How many additional 2.5″ DAEs and drives can the array support?

Which VNX models support a SPE?

You are onsite for a DAE and drive upgrade for a VNX 5800 array. After inspecting the collections

from the array you notice that the VNX has the following active configuration:
1 x 2.5″ DPE
21 x 2.5″ DAE’s
10 x 3.5″ DAE’s
681 bound data and hotspare drives
0 faulted drives
2 unbound drives
How many additional 2.5″ DAEs and drives can the array support?