what is the next step in Replication Manager client actions for creating a replica?
After preparing storage what is the next step in Replication Manager client actions for creating a replica?
What happens to a Replica Resource when an Auto Replication operation finishes?
What happens to a Replica Resource when an Auto Replication operation finishes?
What do you configure to enable automatic fail back?
You configured a DL740 at a customer site using Active Engine Failover. One of the engines fails and the virtual resources fail over to the surviving engine. After replacing the failed engine, the virtual resources do NOT fail back automatically. What do you configure to enable automatic fail back?
What is the recommended procedure for granting a non-administrative user the privilege to operate devices and
What is the recommended procedure for granting a non-administrative user the privilege to operate devices and jukeboxes?
Which pool needs to have a volume available for the clone operation to continue?
The destination volume becomes full during a NetWorker clone operation. Which pool needs to have a volume available for the clone operation to continue?
What is the problem?
You have zoned the front-end ports of a DL310 to each one of the six HBAs on a host. All virtual tape devices have been assigned to all HBAs. The operating system is showing six times the number of virtual devices originally assigned. What is the problem?
When would this combination be used?
The table shows a possible combination for creating virtual tapes when using CLARiiON Disk Library.
When would this combination be used?
which statement describes a single physical host?
In NetWorker, which statement describes a single physical host?
Which RAID type should be used when configuring a CLARiiON backup-to-disk solution with ATA disks for large se
Which RAID type should be used when configuring a CLARiiON backup-to-disk solution with ATA disks for large sequential I/O backup operations?
what happens when C needs to write a save set?
NetWorker storage nodes A, B, and C share tape drives, drv1 and drv2, in an autochanger. If storage node A is writing to drv1 and storage node B is writing to drv2, what happens when C needs to write a save set?