How many seconds after the start of the first cycle will the next cycle start?
In a single-hop SRDF/AR setup, the options have been set as follows:
Cycle Time = 3000
Delay Time = 0
Overflow = Next
The symreplicate session was started at time 0. The actual cycle time was 4500 seconds. How
many seconds after the start of the first cycle will the next cycle start?
Which network protocol is used for handling error and control messages between network devices?
Which network protocol is used for handling error and control messages between network
devices?
How many seconds after the start of the first cycle will the next cycle start?
In a single-hop SRDF/AR setup, the options have been set as follows:
Cycle Time = 3000
Delay Time = 2000
Overflow = Next
The symreplicate session was started at time 0. The actual cycle time was 4500 seconds. How
many seconds after the start of the first cycle will the next cycle start?
Which command is used to test connectivity from one host to another?
Which command is used to test connectivity from one host to another?
What is the shortest period of time that you could examine?
You are sizing the bandwidth needed for a new SRDF/AR implementation. You have Change
Tracker enabled on the volumes designated for replication. You have set the initial mark action at
9:00 A.M. and data is collected every hour for 12 hours. At 12:15 P.M. you look at the SUM report
and begin to examine the results.
What is the shortest period of time that you could examine?
Which EMC Customer Service configuration document must you use to verify Celerra requirements for the backend?
You have been engaged for a new Celerra/Symmetrix implementation. Which EMC Customer
Service configuration document must you use to verify Celerra requirements for the backend?
Which UNIX utility or tool would you use to perform an HP-UX host-based data migration?
Which UNIX utility or tool would you use to perform an HP-UX host-based data migration?
What is the status of Data Mover 2?
What is the status of Data Mover 2?
10 – slot_0 primary control station
5 -slot_2 contacted
5 -slot_3 contacted
Which UNIX utility or tool would you use to perform an IBM AIX host-based data migration?
Which UNIX utility or tool would you use to perform an IBM AIX host-based data migration?
Which command is run to verify CIFS shares on a Data Mover?
Which command is run to verify CIFS shares on a Data Mover?