What is the track protection status on the source volumes set to?
Timefider/Snap session has been created. What is the track protection status on the source
volumes set to?
Which command is used to identify a standby Data Mover?
Which command is used to identify a standby Data Mover?
which conditions will Enginuity remove the consistency exempt attribute from RDF mirror?
Under which conditions will Enginuity remove the consistency exempt attribute from RDF mirror?
IP address: 10.6.230.196 default gateway: 10.6.128.1
A host has the following IP address and default gateway. Select the subnet mask that will allow
the host to access remote networks.
IP address: 10.6.230.196
default gateway: 10.6.128.1
What is the maximum number of symmetrix V-Max initiator groups that can be associated with an initiator?
What is the maximum number of symmetrix V-Max initiator groups that can be associated with an
initiator?
which form of duplex would you recommend?
For a new install, which form of duplex would you recommend?
What is recommended before creating a TimeFinder/Clone replica?
What is recommended before creating a TimeFinder/Clone replica?
What is causing this issue?
A customer is unable to FTP from the Control Station to a host on the same network. The FTP
service is enabled, and running on the Control Station and host. Network connectivity between the
Control Station and host has been verified and is working properly. The customer is able to
contact other hosts on the network from the Control Station. No other network related issues are
being reported.
What is causing this issue?
What is the correct state for the Target R2 and Target BCV prior to issuing a symreplicate start command?
Refer to the Exhibit.
What is the correct state for the Target R2 and Target BCV prior to issuing a symreplicate start
command?
Where do you obtain the release notes?
A new level of EMCNAS code is now available. Where do you obtain the release notes?