A company has a business model where they purchase small companies and let them run
independently. Storage, backup and recovery, and server technology implementations vary
between the companies.
The company has determined that they must initiate a backup and recovery strategy that will allow
for recovery of any of the small companies in case of a complete site failure. In addition, they want
to start to use a single standard model in an effort to move forward towards standardization across
the entire enterprise.
A backup and recovery audit has found that the companies all use a basic method of backup and
recovery consisting of enterprise backup software backing up to a tape library for all critical
corporate data. The company wants to replicate backup sets from each site to their corporate
location.
Which EMC solution should be used to minimize impact on the environment while minimizing
cost?

A customer is piloting an EMC Data Domain system.

Based on the Data Domain statistics shown in the exhibit, which type of data is being backed up?

An EMC NetWorker customer has been using an EMC Disk Library (EDL) for over four years. The
EDL has reached its capacity limits. The customer is in the process of virtualizing as many
physical servers as possible to reclaim data center floor space. They are backing up numerous 8
TB databases.
The customer is interested in replacing the EDL and is concerned about the amount of backup
traffic over the network. The replacement must maintain a single point of backup administration
and reduce backup times for their growing virtualized environment.
What is the recommended solution?

During final design conversations with an EMC Avamar customer, they indicate that they have
certain data that needs to be carefully secured during transit. This data is typically transferred at
different times and in different groups.
Which type of encryption would address the customer’s concern?

Refer to the Exhibit.

A customer is planning to have a disaster recovery solution for their backup environment. As part
of Phase 1, they want a replica for their EMC Data Domain system. Due to some budget
restrictions, they need to have a low investment solution.
What is the recommended minimum configuration needed for the replica?