Refer to the exhibit.

A customer has not followed EMC best practices when cabling their VS2 VPLEX engine. You are
asked how to re-cable the engine to adhere to best practices. What is your response?

Refer to the exhibit.

What is the purpose of VPLEX Witness in a Metro environment?

Refer to the exhibit.

You are preparing to upgrade a VPLEX Metro system. You ran the version command to begin the
verification process and received the output shown.
What is the most likely reason for the warning?

Refer to the exhibit.

NDU pre-check failed because minimal topology is in use. Which parameter can be added to the
ndu start command that will allow the NDU to proceed without error in this situation?

Refer to the exhibit.

Which command must be used to generate this output?

Refer to the exhibit.

A customer is moving some VMAX devices under a VPLEX Local and is using PowerPath as
multipath software. What is the preferred PowerPath load balancing policy assigned to VPLEX
volumes?

Refer to the exhibit.

What is the result of the command?

Refer to the exhibit.

After the “attach-mirror” command is successfully executed on device
“device_VNX0506_CSE__6_1”, the command “rebuild-status” shows an ongoing rebuild process
on the same device.
What is a possible cause?

Refer to the exhibit.

You are planning to perform data mobility between VPLEX Clusters using the GUI. What mobility
job options do you have?

Refer to the exhibit.

After 6 months of operation, you are monitoring the health of the VPLEX system from the
Unisphere Manager for VPLEX.
What is the most likely reason for a state change of the VPLEX Witness?