What is the correct back-end cabling?
A deployment technician needs to install a dual-controller Storage Center with an SC200 enclosure and an
SC280 enclosure.
What is the correct back-end cabling?
Which configuration is causing this issue?
During failover testing, an engineer finds that the iSCSI connection failed over properly when a physical link was
disconnected. The FC connection did NOT failover when a physical link was disconnected.
Which configuration is causing this issue?
What should the engineer conclude?
An engineer is investigating network congestion on the iSCSI network and finds pause frames are rapidly
incrementing on all host and ISL switch ports, but NOT on the array switch ports. All switch ports are configured
for both send and receive flow control.
What should the engineer conclude?
How many fault domains must the engineer configure on t…
An engineer is configuring a storage array in a mixed environment of 10 Gb iSCSI and 16 Gb Fibre Channel.
The 10 Gb iSCSI network consists of two separate VLANs and is used for server connectivity. The 16 Gb Fibre
Channel network consists of a single fabric and is used to provide high-speed replication connectivity to asecondary storage array for Synchronous Live Volume with Auto Failover.
How many fault domains must the engineer configure on the storage array for each network?
Why should the engineer choose a stripe width of 10?
An engineer has configured the storage array for single redundancy across all three tiers in the system. A
change in business requirements is forcing the engineer to convert from single redundancy to dual redundancy.
The engineer is evaluating whether to use the dual redundant RAID 6 with a stripe width of 6 or 10.
Why should the engineer choose a stripe width of 10?
What is the result?
During a Storage Center dual-controller upgrade from SC030 to SC8000, the onsite engineer fails to reload the
configuration to flash on a controller.
What is the result?
What should be selected on the IO card change wizard du…
What should be selected on the IO card change wizard during an upgrade if the slot/port combination is no
longer used?
Which initial set of commands should the engineer choose?
An engineer needs to use a set of commands to initialize a new SC8000 with serial numbers 12345 & 12346
from the CLI.
Which initial set of commands should the engineer choose?
which two advanced options are available when creating …
During the setup wizard, which two advanced options are available when creating a disk folder? (Choose two.)
Which command will successfully set the eth0 IP address…
Which command will successfully set the eth0 IP address on an SC4020 controller to 172.16.14.5 with a subnet
mask of 255.255.255.0?