Which customizable, proactive tool should be configured…
A customer has a newly installed storage array. The customer needs to proactively monitor and report
storage utilization on a regular basis.
Which customizable, proactive tool should be configured to perform this task?
Which port mode should the engineer use to meet this re…
An engineer is configuring fault domains and front-end IO ports on a dual controller storage array. Any
volumes that are later created and mapped to a server must be active/optimized on one controller and
standby on the other controller.
Which port mode should the engineer use to meet this requirement?
How many targets and initiators should each zone includ…
A zone must include at least one target and at least one initiator.
How many targets and initiators should each zone include according to recommended best practice?
What are two 1 Gb iSCSI best practices to set up and-to…
What are two 1 Gb iSCSI best practices to set up and-to-end connectivity (servers, switch, and storage)?
(Choose two.)
How many fault domains are required?
An engineer needs to install an SC8000 with four FC ports in each controller and two FC switches set up in
a dual fabric. Each controller also has two 10 Gb iSCSI ports. All iSCSI ports are connected to an ethernet
switch. The system uses virtual ports.
How many fault domains are required?
Which two configurations are required to set up the fau…
A deployment engineer is installing a dual-controller Storage Center with four FC ports in each controller.
This system need to use Legacy Port mode because the AIX version used requires it.
Which two configurations are required to set up the fault domains? (Choose two.)
Which WWNs from the Storage Center need to be included …
An engineer has several servers connected to the Storage Center through two FC fabrics. The Storage
Center runs in Virtual Ports mode. The engineer needs to create zones based on World Wide Names
(WWN).
Which WWNs from the Storage Center need to be included in the zone with the server WWN?
What is causing the problem?
There are several servers connected to the Storage Center through Fibre Channel (FC) fabrics using WWN
zoning. The engineer has recently replaced a server’s FC HB. This server can no longer connect to the
Storage Center.
What is causing the problem?