DRAG DROP
GigSwitch1 is currently configured with a speed of 100 and Duplex is set to Auto on all interfaces.

Interface 2 will be connected to GigSwitch2 which is used for all departments. Interface 1 will be
used for HR traffic only.
GigSwitch1 needs to be configured with the following parameters:
Configure the necessary protocol to prevent switching loops
Configure GigSwitch1 with a /24 IP address for management
Traffic across Interface 1 needs to be forced to accept and receive up to 100Mbps data at the
same time
Traffic across Interface 2 needs to be forced to use Gigabit speeds and maximum performance
Drag and drop the appropriate configurations to their corresponding requirements. All placeholders
must be filled. Not all configurations will be used.

CORRECT TEXT
Workstations are unable to access the internet after a recent power outage. Configure the
appropriate devices to ensure All workstations have internet connectivity.

Which of the following is an example of a CSMA/CD medium?

Which of the following copper cable types should be chosen to run gigabit speeds through a
dropped ceiling that returns airflow?

A technician tests a cable going to the patch panel and notices the following output from the cable
tester:
1——————1
2——————2
3——————3
4——————4
5——————5
6——————6
7——————7
8——————8
On a T568A standard CAT5e cable, which of the following wire strands is the cause of this
connectivity issue?

Which of the following components of wiring distribution is referred to as the core communications
closet for an organization?

Users notice a problem with their network connectivity when additional lights are turned on. Which
of the following would be the cause for this problem?

A user does not have network connectivity. While testing the cable the technician receives the
below reading on the cable tester:
1———–1
2———–2
3———–3
4———–4
5———–5
6———–6
7———–7
8———–8

Which of the following should the technician do NEXT?

Management wants to be sure that the existing wiring infrastructure conforms to CAT5e standards.
Which of the following is the correct tool?

In contrast to earlier Wi-Fi speeds, which of the following BEST describes the antenna and
channelization properties used in 802.11n?