A user informs the network administrator of increasingly common wireless connection problems.
The administrator determines the user has recently received a new cordless phone. The phone is
MOST likely causing which of the following conditions?

A network administrator has just been notified about the loss of Internet connectivity. Another
technician had just performed non-scheduled maintenance and mentioned that some cabling may
have been moved. Which of the following MOST likely caused the loss of Internet connectivity?

A user reports that they keep getting disconnected on the wireless network. After further
investigation, the technician confirms that this occurs only in that user’s office. Which of the
following would MOST likely cause them to lose their connection?

A new SOHO wireless network is set up using two access points with separate SSIDs on the
same frequency. However, the users are experiencing intermittent connectivity on both SSIDs.
Which of the following is the problem?

A user at a small business states that they cannot connect to the Internet via the company’s

wireless network every time their cordless phone rings. Which of the following is MOST likely
occurring?

A technician is troubleshooting a desktop computer that will not power on. After replacing the
power supply, the technician tries to start the desktop, but it still fails to power on. Which of the
following troubleshooting steps should the technician do NEXT?

A technician grabs a network cable and connects two switches together. However, the ports fail to
come up as indicated by the link lights. Which of the following is MOST likely the issue?

A stateful point to point wireless connection going down for a few hours at a time is MOST likely
due to which of the following?

An administrator would like to get more speed out of a wireless network. The administrator
decides to configure the AP with a frequency width of 40MHz. Which of the following features is
the administrator MOST likely using?

A technician is installing a switch that will be used for VoIP and data traffic. The phones do not
support the 802.3af standard. Which of the following should the technician configure on the
switch?