DRAG DROP
GigSwitch1 is currently configured with a speed of 100 and Duplex is set to Auto on all interfaces.
Interface 2 will be connected to GigSwitch2 which is used for all departments. Interface 1 will be
used for HR traffic only.
GigSwitch1 needs to be configured with the following parameters:
Configure the necessary protocol to prevent switching loops
Configure GigSwitch1 with a /24 IP address for management
Traffic across Interface 1 needs to be forced to accept and receive up to 100Mbps data at the
same time
Traffic across Interface 2 needs to be forced to use Gigabit speeds and maximum performance
Drag and drop the appropriate configurations to their corresponding requirements. All placeholders
must be filled. Not all configurations will be used.

CORRECT TEXT
Workstations are unable to access the internet after a recent power outage. Configure the
appropriate devices to ensure All workstations have internet connectivity.

CORRECT TEXT
Wireless network users recently began experiencing speed and performance issues after access
point 2 (AP2) was replaced due to faulty hardware. The original network was installed according to
a consultant’s specifications and has always worked without a problem.
You a network technician, have been tasked with evaluating the situation and resolving the issues
to improve both performance and connectivity. Refer to the following diagram and perform any
Necessary changes to the wireless and wired infrastructure by adjusting devices.
Note. Adjust the LEAST number of devices needed to fix the issue all blue icons in the image are clickable.

The DHCP server leases IP addresses 10.162.233.158 to WBAC11 for a period of 14 days. At
which of the following times would WBAC11 send an initial request to the DHCP server to renew
the IP address lease?

A technician is trying to add another switch to the network with multiple VLANs. Which of the
following should the technician configure on the interface to allow multiple VLANs?

A user calls the helpdesk to report not being able to access network resources over the company’s
Wi-Fi connection. During information gathering, the user mentions that the wireless network their
computer is signed into is not the same name as it had been previously. Which of the following is
the underlying cause?

A user moves from one office to another. When the user logs onto their computer, it has local
access to shared drives but no Internet access. A technician determines that the computer has an
IP address in the wrong subnet. Which of the following is MOST likely the cause?

A consultant is installing new WAPs for an office using wall mounts. Which of the following is the
BEST location for the new boxes for signal strength and coverage?

A company has multiple WAPs within close proximity to each other to allow users to move about
seamlessly through the building with their laptops, without losing any connection. However, this
has had the opposite effect, causing any user that is close to two of the access points to
constantly reconnect to the wireless network. Which of the following should be changed on all the
WAPs to allow this to work as the customer intended?

A user is unable to communicate with any local network resources, but is connected to the
wireless network and can access the Internet. The network technician notices that the laptop has
an incorrect IP address, even though it shows it is connected. Which of the following is the MOST
likely cause?