A technician notices a rack mounted server is beeping without booting up. The NEXT step to
diagnose this issue would be to:

A technician is experiencing overheating on a rack mounted server. After powering off and
removing the cover of the server, a large amount of dust is noticed on one of the fans. After cleaning
out the dust and powering the server back on, the server is still overheating. Which of the following
would BEST explain this issue?

A datacenter technician encounters a power receptacle labeled NEMA L5-30. Which of the
following powers is this socket rated for?

Two RAID arrays are created from eight disks. One is created using RAID 6, the other is created
using RAID 5 with a hot spare. Which of the following is the operational difference between these
configurations?

A technician is assigned a task to configure a new server with six hard drives. The senior
administrator requested the technician utilize the drives for maximum fault tolerance. Which of the
following RAID configurations should the technician use?

A system administrator is troubleshooting a network connectivity issue and runs ipconfig/all on the
host. The command returns the following:
IPv4 Address: 169.254.0.12
Subnet mask: 255.255.0.0
The client is configured for DHCP. Which of the following commands should be run on the client to
resolve this issue? (Select TWO.)

Several of the finance department computers are experiencing timeouts while in their financial
program. The program will not open or close; however, the previous day the program was running
without issues. Which of the following is MOST likely the cause of this problem?

An administrator is asked to change a configuration using a GUI on a Windows server, but does
not have access to a KVM. Which of the following is BEST to make the change?

Which of the following allows virtual machines to share the NIC of the host?

A network administrator is installing additional devices on the network. Currently, the network
segment is utilizing all allocated IP addresses. If there are additional addresses available, which of
the following would be BEST for the network administrator to perform to accommodate the new
network devices?