Which of the following types of systems is created by combining many signals into an existing
single cable?

A design calls for the installation of devices using the current AC wiring for control. The
installation is complete, and the technician discovers that only one-half of the devices can be
accessed from the central processor. Which of the following steps will resolve this problem?

Which of the following information is NOT required when a technician is programming a
control system?

If the technician has verified that all the phone jacks but one in a home have a dial tone, the next
step the technician should take is to check.

Which of the following topologies is associated with the home run method?

In a Category 5 cable, each pair has a different twisit rate to.

Which of the following connectors is the eight pin connector used for data transmission over
twisted pair wires? Pin connector used for data transmission over standard telephone wires.

Which of the following connectors is used in the Community Access Television (CATV)
industry on coaxial cable?

Which of the following device interfaces may be used to allow remote connectivity and control
of subsystem?

In order for devices to communicate and integrate over the home LAN infrastructure, the home
integrate should ideally connect into these sub systems at the associated sub system.