Which of the following TCP/IP model layers does the OSI model Presentation layer map to?
Which of the following TCP/IP model layers does the OSI model Presentation layer map to?
which of the following steps should be performed NEXT?
After a technician has identified the problem and its impact, which of the following steps should be
performed NEXT?
Which of the following wireless standards has a MAXIMUM transfer rate of 11Mbps?
Which of the following wireless standards has a MAXIMUM transfer rate of 11Mbps?
which of the following wire strands is the cause of this connectivity issue?
A technician tests a cable going to the patch panel and notices the following output from the cable
tester:
1——————1
2——————2
3——————3
4——————4
5——————5
6——————6
7——————7
8– –8
On a T568A standard CAT5e cable, which of the following wire strands is the cause of this
connectivity issue?
Which of the following monitoring devices are used only to recognize suspicious traffic from specific software
Which of the following monitoring devices are used only to recognize suspicious traffic from specific
software?
Which of the following LAN technologies is used to provide a MAXIMUM bandwidth of 1Gbps through single mode fi
Which of the following LAN technologies is used to provide a MAXIMUM bandwidth of 1Gbps
through single mode fiber?
which of the following network devices?
Spanning-Tree Protocol is used with which of the following network devices?
which of the following network optimization methods?
In a SOHO environment, placing a VoIP unit on the outside edge of a LAN router enhances which of
the following network optimization methods?
Which of the following is MOST likely the problem?
The network support team is constantly getting calls from users in a specific area of an office
building. The users are able to connect to the office wireless network, but they sometimes
disconnect or experience very slow download speeds. Which of the following is MOST likely the
problem?
Which of the following should be configured to allow this?
A technician wants to separate networks on a switch. Which of the following should be configured to
allow this?
