A user does not have network connectivity. While testing the cable the technician receives the
below reading on the cable tester:
1———–1
2———–2
3———–3
4———–4
5———–5
6———–6
7———–7
8———–8
Which of the following should the technician do NEXT?

Which of the following is the MAXIMUM rated speed for CAT5 cabling?

Which of the following standards can operate at either 20MHz or 40MHz channel spacing?

Which of the following is the difference between 802.11b and 802.11g?

In contrast to earlier Wi-Fi speeds, which of the following BEST describes the antenna and
channelization properties used in 802.11n?

Which of the following defines a rack located in an office building between the main rack and other
office equipment?

Which of the following cable types is required to run through an air duct?

Ann, a technician, is installing network cables for an office building. Some of the cables are not
showing active on the switch even when moved to different ports. Which of the following is MOST
likely the cause?

A technician notices a newly installed CAT5 cable is longer than the standard maximum length.
Which of the following problems would this MOST likely cause?

A technician has been dispatched to investigate connectivity problems of a recently renovated
office. The technician has found that the cubicles were wired so that the network cables were run
inside the conduit with the electrical cabling. Which of the following would MOST likely resolve the
connectivity issue?