A technician is installing 802.11a wireless access points in an open warehouse 300 feet (91.44
meters) long and 200 feet (60.96 meters) wide. Which of the following would be the LEAST number
of devices needed to provide coverage to the entire building?

A network technician is designing a SOHO environment where cost is a consideration. The
requirements include access to the Internet and access to the guest house which is 100 feet away.
The location of the Internet modem is located in the main house. Which of the following is the BEST
option to accomplish these requirements?

A technician is troubleshooting a network camer
a. The technician restarted the modem and now the camera is no longer available from a mobile
device. Which of the following has MOST likely occurred?

When examining a suspected faulty copper network cable, Kim, the administrator, notices that some
of the pairs are untwisted too much. This is MOST likely causing which of the following?

Jeff, an administrator, is using a punch-down tool to connect a cable. To which of the following is Jeff
MOST likely connecting?

Which of the following uses copper wiring?

T568B wiring scheme is typically found on which of the following components?

In which of the following wireless standards is MIMO used?

Zach, a network administrator, is checking work on some new CAT5 LAN network cabling installed at
an organization. Multiple lines are receiving poor signals, and Zach finds the lengths of the runs to be
sometimes over 350 feet (107 meters). Which of the following is the cause of the issue?

Kim, a technician, is asked to run new cabling for an office that is 350 feet (107 meters) away from
the networking equipment. The type of cable being run is CAT6. Kim purchases and installs a 500
foot (152 meters) CAT6 cable, but after installation, notices a weak signal between the office and the
networking equipment. Which of the following would have been the BEST to install instead of the
CAT6 cable?