Which of the following is a possible cause of the problem?
When using an electric heater sitting next to the network jack the printer prints slowly. With the
heater turned off there is no problem. Which of the following is a possible cause of the problem?
Which of the following is a possible cause of the problem?
When scanning a document through an ADF the customer notices a thin black line from the lead
edge to trail edge of the original. Which of the following is a possible cause of the problem?
Which of the following should be done next?
A technician has determined that the fuser is causing lines. Which of the following should be done
next?
Which of the following is used to remove the airborne byproduct caused by the charging of the photoconductor?
Which of the following is used to remove the airborne byproduct caused by the charging of the
photoconductor?
Which of the following should be referenced before installing a device in an enclosed area?
Which of the following should be referenced before installing a device in an enclosed area?
which of the following will be affected?
When scanning a document at a high resolution which of the following will be affected?
Which of the following is affected when scanning at a higher resolution?
Which of the following is affected when scanning at a higher resolution?
Which of the following should the technician recommend that the customer do next?
After installing a new printer, a customer finds that it prints random characters. The customer has
updated the driver with an update wizard. Which of the following should the technician recommend
that the customer do next?
why would a technician print an internal test sheet?
When an MFD has lines on its output, why would a technician print an internal test sheet?
Which of the following methods is the BEST way to attach the MFP to the network?
A new MFP is installed, but the customer has not provided an IP address. Which of the following
methods is the BEST way to attach the MFP to the network?