DRAG DROP
A customer’s email server is not sending emails. Arrange the troubleshooting steps in the order the technician
should perform them:
Select and Place:

DRAG DROP
Wireless network users recently began experiencing speed and performance issues after access point 2 (AP2)
was replaced due to faulty hardware. The original network was installed according to a consultant’s
specifications and has always worked without a problem.
You a network technician, have been tasked with evaluating the situation and resolving the issues to improve
both performance and connectivity. Refer to the following exhibits and perform any necessary changes to thewireless and wired infrastructure by adjusting devices. Note: Adjust the LEAST number of devices needed to fix
the issue.
Select and Place:

DRAG DROP
Your company recently purchased a new building down the street from the existing office.
For each of the tasks below, select the appropriate antenna type and encryption object for all wireless access
point (AP).
1. Create an encrypted wireless connection between the two buildings that BEST controls signal propagation,
while maximizing security.
2. Restrict the wireless signal generated by the access points (AP’s) inside Building 1, so that it minimizes
broadcast beyond the building.
3. Maximize wireless coverage inside Building 1.
4. Building 1’s internal wireless network is for visitors only and must not require any special configuration on the
visitor’s device to connect.
Select and Place:

CORRECT TEXT
SIMULATION
After recent changes to the pictured network, several users are unable to access the servers. Only PC1, PC2,
PC3, and PC4 are configurable. You can only change the adapter configurations to each PC.

Which of the following PDUs is used by a connectionless protocol?

Which of the following devices implements CSMA/CA virtually through the RTS/CTS protocols?

Which of the following WAN technologies is associated with high latency?

Which of the following helps prevent routing loops?

CORRECT TEXT
SIMULATION
After recent changes to the pictured network, several users are unable to access the servers. Only PC1, PC2,
PC3, and PC4 are clickable and will give you access to the command prompt and the adapter configuration
tabs.
Instructions: Verify the settings by using the command prompt, after making any system changes. Next, restore
connectivity by making the appropriate changes to the infrastructure. When you have completed these steps,
select the Done button to submit.

Which of the following is a security benefit gained from setting up a guest wireless network?