Which of the following protocols is MOST commonly associated with VoIP?

Which of the following commands will provide an administrator with the number of hops a packet
takes from host to host?

Which of the following is needed when using WPA2-Enterprise wireless encryption?

A technician has a network with a mix of newer and older equipment. Which of the following
settings would dynamically configure whether to use full or half duplex?

Which of the following can MOST likely cause intermittent connection problems with a CAT5
network cable?

CORRECT TEXT
Wireless network users recently began experiencing speed and performance issues after access
point 2 (AP2) was replaced due to faulty hardware. The original network was installed according to
a consultant’s specifications and has always worked without a problem.
You a network technician, have been tasked with evaluating the situation and resolving the issues
to improve both performance and connectivity. Refer to the following diagram and perform any
Necessary changes to the wireless and wired infrastructure by adjusting devices.
Note. Adjust the LEAST number of devices needed to fix the issue all blue icons in the image are clickable.

CORRECT TEXT
Workstations are unable to access the internet after a recent power outage. Configure the
appropriate devices to ensure All workstations have internet connectivity.

DRAG DROP
GigSwitch1 is currently configured with a speed of 100 and Duplex is set to Auto on all interfaces.

Interface 2 will be connected to GigSwitch2 which is used for all departments. Interface 1 will be
used for HR traffic only.
GigSwitch1 needs to be configured with the following parameters:
Configure the necessary protocol to prevent switching loops
Configure GigSwitch1 with a /24 IP address for management
Traffic across Interface 1 needs to be forced to accept and receive up to 100Mbps data at the
same time
Traffic across Interface 2 needs to be forced to use Gigabit speeds and maximum performance
Drag and drop the appropriate configurations to their corresponding requirements. All placeholders
must be filled. Not all configurations will be used.

DRAG DROP
A customer’s email server is not sending emails. Arrange the troubleshooting steps in the order
the technician should perform them:

Which of the following is an example of a CSMA/CD medium?