A network technician has been assigned to install an additional router on a wireless network. The router has a different SSID and frequency. All users on the new access point and the main network can ping each other and utilize the network printer, but all users on the new router cannot get to the Internet.Which of the following is the MOST likely cause of this issue?

While troubleshooting a network outage, a technician finds a 100-meter fiber cable with a small service loop and suspects it might be the cause of the outage.
Which of the following is MOST likely the issue? leakage of light through the fiber cladding and this is more likely to happen where the fiber is excessively bent.

A technician is tasked with connecting a router to a DWDM. The technician connects the router to the multiplexer and confirms that there is a good signal level. However, the interface on the router will not come up.
Which of the following is the MOST likely cause? selected input into a single line. A demultiplexer (or demux) is a device taking a single input signal and selecting one of many data-output-lines, which is connected to the single input. Since the signal going in is good, the problem must be with the signal output. If the correct wavelength was demultiplexed, the interface will be displayed on the router.

A technician is troubleshooting a wired device on the network. The technician notices that the link light on the NIC does not illuminate. After testing the device on a different RJ-45 port, the device connects successfully.
Which of the following is causing this issue?

A technician recently ran a 20-meter section of CAT6 to relocate a control station to a more central area on the production floor. Since the relocation, the helpdesk has received complaints about intermittent operation.
During the troubleshooting process, the technician noticed that collisions are only observed on the switch port during production.
Given this information, which of the following is the cause of the problem? connecting the control station to the switch port is now surrounded by the production machinery.

SIMULATION
Wireless network users recently began experiencing speed and performance issues after access point 2 (AP2) was replaced due to faulty hardware. The original network was installed according to a consultant’s specifications and has always worked without a problem.
You, a network technician, have been tasked with evaluating the situation and resolving the issues to improve both performance and connectivity. Refer to the following diagram and perform any NECESSARY changes to the wireless and wired infrastructure by adjusting devices.
Note: Adjust the LEAST number of devices needed to fix the issue, all blue icons in the image are clickable.
When you feel the simulation is complete please select the Done button.

A network technician has received a help desk ticket indicating that after the new wireless access point was installed, all of the media department’s devices are experiencing sporadic wireless connectivity. All other departments are connecting just fine and the settings on the new access point were copied from the baseline.
Which of the following is a reason why the media department is not connecting? would solve the problem.

Ann, a user, is experiencing an issue with her wireless device. While in the conference area, the wireless signal is steady and strong. However, at her desk the signal is consistently dropping, yet the device indicates a strong signal.
Which of the following is the MOST likely cause of the issue? mirrors, carpeted floors, and many other objects. This results in the slow connection. The radio waves are travelling at the same rate, but as a result of signal bounce, it’s taking longer to reach its destination.

A network technician is performing a wireless survey in the office and discovers a device that was not installed by the networking team.
This is an example of which of following threats? aware of it. Therefore, if the device was not installed by the networking team, the administrator would not know about it being there.

A user connects to a wireless network at the office and is able to access unfamiliar SMB shares and printers.
Which of the following has happened to the user?