A network’s design includes gateways connecting an assembly-line network. The assembly-line network users specialized cabling and interfaces to allow the assembly-line robots to communicate with one another.
The IP is connecting the technician workstations with which of the following network types?

A firewall technician has received calls stating the network is running slowly. The technician has found the firewall is functioning properly.
Which of the following should the technician review to determine the cause of the slow performance?

An organization is required to implement a wireless network. The organization must implement wireless routers compatible with 802.11ac protocol that have maximum possible range.Which of the following wireless router frequencies is a viable option?

A network administrator is comparing several different wireless technologies. To calculate the effective maximum file transfer rate instead of the theoretical, which of the following should be measured?

In a network that requires multilayer switches to use authentication via RADIUS/TACACS+, which of the following access control models will the switches need to utilize?

A network technician replaced a faulty Ethernet cable. The technician replaced one side of the patch in the incorrect part of the patch panel. Within a few minutes, the technician was informed that users were experiencing slow or no Internet connectivity all over the building. A broadcast storm began.
After removing the replacement cable, which of the following should the technician do NEXT?

A network technician is responsible for the basic security of the network. Management has asked if there is a way to improve the level of access users have to the company file server. Right now, any employee can upload and download files with basic system credentials.
Which of the following would require additional credentials?

A network engineer has been tasked with designing a network for a new branch office with approximately 50
network devices. This branch office will connect to the other offices via a MAN. Many of the other branch offices use off-the-shelf SOHO equipment. It is a requirement that the routing protocol chosen use the least amount of overhead. Additionally, all computers on the network will be part of a single VLAN. The connection between these computers should produce the highest throughput possible, in the most cost effective manner.
Which of the following devices would be MOST appropriate? computers. RIPv2 has a lower overhead as required in the question. computers would require Fibre Channel network adapters that do not come as standard on off-the-shelf computers. than a 1Gbps network switch. Furthermore, the computers would require MIMO network adapters that do not come as standard on off-the-shelf computers. the same VLAN. Therefore, there is no need for inter-VLAN routing so a layer 3 switch is not required. OSPF

An administrator notices an abnormally high level of network traffic from a server. Upon logging into the server, the administrator runs the following command:

Which of the following should the administrator use to correlate the active connection with the running service?

A technician is troubleshooting a desktop connectivity issue. The technician believes a static ARP may be causing the problem.
Which of the following should the technician do NEXT according to the network troubleshooting methodology?