Scenario: Primary NetScaler (NS1) is licensed for 10000 Maximum ICA users and 305
Access Gateway users. Secondary NetScaler (NS2) is licensed for 10000 Maximum ICA
users and five Access Gateway users. From where and which command should a network
engineer run to display diagnostics on the licenses?

NSROOT is the only account configured with super user rights. In order to initiate the
password recovery procedure, the engineer must __________. (Choose the correct option
to complete the sentence.)

A network engineer should use a HTTP-ECV monitor type to control the status of a load
balanced web server resource when __________. (Choose the correct option to complete
the sentence.)

Scenario: A network engineer has installed a NetScaler system into their corporate DMZ
and would like to provide access to a web server on the internal LAN. The web server will
be accessed by external users through the NetScaler. The firewall administrator has opened
the relevant ports required on the external and the internal firewall. The engineer notices
that the virtual server and services representing the web server are down and the internal
web server does NOT appear accessible from the NetScaler. What could be the cause of
this?

Scenario: A network engineer has configured an HTTP application to be load balanced
using a virtual server named Svr1. Users have reported intermittent errors and the engineer
has been given the client IP address of an affected user and asked to determine which back
end service they are connected to. Using the command-line interface, how could the

engineer find this information?

A network engineer is troubleshooting a situation where ARP requests for IPs in other
subnets (for example 10.192.12.80) are appearing in the 10.192.8.0/24 subnet. Which
command could the engineer run on the NetScaler to verify IP to VLAN bindings?

Scenario: An engineer needs to configure a monitor to ensure that each server is tested
every 10 seconds and requires that the server pass the test four consecutive times before
marking a server as UP. If the test fails, the server should be marked as down for 60
seconds. To configure the monitor, the engineer should configure an interval of 10 seconds,
down-time of 60 seconds; __________ as 4; and retries as __________. (Choose the
correct set of options to complete the sentence.)

An engineer has configured a DNS virtual server on a NetScaler appliance but the monitors
are showing DOWN and DNS resolution is failing. Which of the following should the
engineer check?

A network engineer should use the Advanced tab when configuring load balancing to
enable __________. (Choose the correct option to answer the question.)

Scenario: A network engineer has created and bound an UDP-ECV monitor to identify the
status of a UDP service. However, no matter what the response is, the service is always
marked as UP. A possible cause of this behavior is that the network engineer __________.
(Choose the correct option to complete the sentence.)