what are two valid parameters?
When configuring an advanced HTTP callout based on attributes, what are two valid
parameters? (Choose two.)
Which two actions can the network engineer take to restore communications to the appliance?
Scenario: A network engineer configured a new NetScaler MPX appliance without any
VLANs and with a single interface connected to the network. The engineer has not
completed any other configurations. The interface is then accidentally disabled and contact
is lost with the appliance. Which two actions can the network engineer take to restore
communications to the appliance? (Choose two.)
Which command could the engineer run on the NetScaler to verify IP to VLAN bindings?
A network engineer is troubleshooting a situation where ARP requests for IPs in other subnets (for example
10.192.12.80) are appearing in the 10.192.8.0/24 subnet.
Which command could the engineer run on the NetScaler to verify IP to VLAN bindings?
Which two steps must the network engineer complete to resolve this?
A security test has been completed on an SSL offload implementation and it has been
determined that the certificate key length is too short and must be increased. Which two
steps must the network engineer complete to resolve this? (Choose two.)
(Choose the correct set of options to complete the sentence.)
Scenario: An engineer needs to configure a monitor to ensure that each server is tested every 10 seconds and
requires that the server pass the test four consecutive times before marking a server as UP. If the test fails, the
server should be marked as down for 60 seconds.
To configure the monitor, the engineer should configure an interval of 10 seconds, down-time of 60 seconds;
__________ as 4; and retries as __________. (Choose the correct set of options to complete the sentence.)
which two certificate formats are supported by NetScaler?
When binding a certificate to a virtual server, which two certificate formats are supported by
NetScaler? (Choose two.)
which two things should a network engineer verify in the environment?
When configuring NetScaler authentication to access a web site, which two things should a
network engineer verify in the environment? (Choose two.)
Which of the following should the engineer check?
An engineer has configured a DNS virtual server on a NetScaler appliance but the monitors are showing DOWN
and DNS resolution is failing.
Which of the following should the engineer check?
Which three of the following pieces of information will be included in the archive file?
A NetScaler engineer generates a techsupport archive to be sent to Technical Support.
Which three of the following pieces of information will be included in the archive file?
(Choose three.)
(Choose the correct option to answer the question.)
A network engineer should use the Advanced tab when configuring load balancing to enable __________.
(Choose the correct option to answer the question.)